Using this adapter, connect your portable monitor that uses x2 hole 100mm VESA mount to any 1/4"-20 friction arm for easy mounting. This version is meant for portable monitors that have x2 100mm VESA screw holes. I also make a 4 screw version for monitors like the UPERFECT portable monitors that have 75mm holes. PLEASE VERIFY IF YOUR MONITOR HAS 75mm OR 100mm VESA BEFORE ORDERING AS ITEMS ARE MADE TO ORDER AND NON-REFUNDABLE.

THREE OPTIONS
- Standard: 1/4-20 and VESA holes are both centered
- Offset: If your monitor VESA holes are close to the lip/edge
- Cable Clip: Built in clips for cable management, slots for cable/zip ties
(All three options will work with any x2 hole 100mm vesa monitor. It's purely an aesthetic choice)

Video on how they work: https://youtu.be/Xuy1Fi_Bef8?si=m2AurfSawliAb4U3

KEY FEATURES
- Converts VESA 100mm to 1/4"-20 for use with mounting hardware
- Compatible with 1/4"-20 mounts that use safety pins for anti-rotation (like the smallrig rosette)
- 3D Printed using black glass-fiber PETG, strong and beautiful

INCLUDED IN THIS KIT
- [x1] 100mm to 1/4"-20 adapter
- [x1] 1/4"-20 brass threaded insert (installed in adapter)
- [x2] m4 x 8mm thumbscrews (with Phillips head compatibility)

IMPORTANT NOTICES ABOUT PRODUCT
(1) While the PETG-Glass Fiber filament is both flexible and strong, with enough force they can snap. They are NOT designed to flex a lot, but moreso to be a solid foundation for cables to be secured to. 

(2) The VESA adapters are for portable monitors ONLY. Portable monitors typically weigh between 1-3lbs. While these adapters could* be used with larger monitors as they have the same 100mm layout, they are not designed to hold all of the extra weight. If you have an iPad with a vesa mount, just check to make sure the weight is not over 8lbs and test the part with the mount before permanently mounting.

(3) All parts are 3D printed using Glass Fiber PETG filament.

(4) NackHabitat does their part to save the planet. Shipping materials are made from recyclable materials and some are even made in house. a) Some products are shipped using cardboard that was previously used for shipping. This cardboard may have markings, scuffs, bends, logos, etc. b) Cardboard and paper is cut with a laser that may produce a small amount of dust or paper bits. c) Parts are wrapped using recyclable honeycomb paper that can leave a small amount of residue on part. Wipe any dust residue that may have collected from recyclable shipping materials and you're good to go, none of it is permanent.

(5) SmallRig friction arm or colored anodized thumbscrews shown in photos are not included. As of Jan. 22nd 2026 all colored thumbscrews were removed and replaced with black or white thumbscrews that have Phillips (+) head compatibility.